Model 600

Products

Intercom Entry Systems

600 Series

Model 600

Model 600 Advanced Entry System with Optional Proximity Reader - Pole Mount

Overview

Advanced Entry System with optional HID Proximity reader
Features of Model 600
- IR LED illumination for night viewing of Hi Res Color Camera (Sony ExView)
- “Draw bridge” hinges hold unit in horizontal position for easy service
- Integrated 12 vDC power supply (requires only one power supply)
- Tamper switch output can be connected to alarm system
- Auxiliary bell contact provided for automation system or camera / DVR
- Illuminated Essex piezo bell button
- Illuminated keypad
- HID Proximity Reader (optional)
- Components are mounted to sub-chassis which is inserted into rough-in box at time of installation
Specify keypad type desired:
- Serial ASCII output 600-A
- Output for C2N-IIF 600-CR
- Stand-alone 12 Button 600-S12
- 26 Bit Wiegand output 600-W
Box dimensions 8.25” x 5.75” x 7.5” (h w d)

EXAMPLE PART NUMBER:

600-A-CR-ALU
Model 600 with ASCII keypad, and Crestron intercom, in brushed aluminum finish

MODEL 600-X-CR -Crestron version includes 12 button keypad which is compatible with C2N-IIF. Includes C2N-IIF
MODEL 600-X-VIK* - High performance version using Viking components. System uses “half-duplex” communication, allowing for high speaker and microphone volume. More Details
For Panasonic, use 600-X-VIK with PAN-1 adapter

*NOTE: The “X” in the part numbers above is for keypad specification.

Camera

High Performance Color Camera with LED Illumination SCM510HD-2

Signal
Pick-up Device
Lens
Minimum Illumination
Field of View
Resolution
S/N Ratio
Back Light Comp
Temperature Range
Voltage
Power Consumption

NTSC
1/3” Color Sony ExView CCD 410K
3.6 mm
0.00 lux
115 degrees
560 lines
more than 48 dB
Auto
-10 - 50 degrees C
12 vdc
100 ma

Keypad

ASCII Format: Selectable baud rate, parity, and mode.
Crestron Format: Compatible with Crestron intercom interface (C2N-IIF)
Stand-Alone 12 Button: 500 codes, 1 relay in keypad, 2 additional relays can be added.
Wiegand Format: 26 bit Wiegand output.

HOLO P/N	Format	No. of Users	No. of Relays	Buttons	Pwr Supply	Illumination	Essex P/N
A	ASCII	Depends on controller type and features	Depends on controller type and features	12	Powered by controller	Illumination can be on all of the time. Must be configured at keypad set-up	K1-26I
CR	For Crestron C2N-IIF	Depends on set-up of Crestron system	Depends on set-up of Crestron system	12	Powered by C2N-IIF	Programmable: ON with button press ON all of the time OFF all of the time	KP-26TI
S12	Stand-alone no controller required	500	1 Plus 2 grounding outputs -external relays required	12	12 VDC 1.25 A supplied	Illumination can be on all of the time. Must be configured at keypad set-up	SKE-26I
W	26 Bit Wiegand	Depends on controller type and features	Depends on controller type and features	12	Powered by controller	Cut jumper wire - turns illumination on all of the time	KTP-102LI