Model 700

Products

Intercom Entry Systems

700 Series

Model 700

Model 700 Advanced Entry System with Optional Proximity Reader - Flush Mount

Overview

Advanced Entry System with optional HID Proximity reader
Features of Model 700
- IR LED illumination for night viewing of Hi Res Color Camera (Sony ExView)
- “Draw bridge” hinges hold unit in horizontal position for easy service
- Integrated 12 vDC power supply (requires only one power supply)
- Tamper switch output can be connected to alarm system
- Auxiliary bell contact provided for automation system or camera / DVR
- Illuminated Essex piezo bell button
- Illuminated keypad
- HID Proximity Reader (optional)
Specify keypad type desired:
- Serial ASCII output 700-A
- Output for C2N-IIF 700-CR
- Stand-alone 12 Button 700-S12
- 26 Bit Wiegand output 700-W
Face plate dimensions 9.5” x 7.25” (h w)
Back box dimensions 8.75” x 6.5” x 4.25” (h w d)

EXAMPLE PART NUMBER:

700-CR-CR-ORB
Model 700 with Crestron keypad, and Crestron intercom, in oil rubbed bronze finish

MODEL 700-X-CR -Crestron version includes 12 button keypad which is compatible with C2N-IIF
Includes C2N-IIF
MODEL 700-X-VIK* - High performance version using Viking components. System uses “half-duplex”
communication, allowing for high speaker and microphone volume. More Details
For Panasonic, use 700-X-VIK with PAN-1 adapter

*NOTE: The “X” in the part numbers above are for keypad specification.

Keypad

ASCII Format: Selectable baud rate, parity, and mode.
Crestron Format: Compatible with Crestron intercom interface (C2N-IIF)
Stand-Alone 12 Button: 500 codes, 1 relay in keypad, 2 additional relays can be added.
Wiegand Format: 26 bit Wiegand output.

HOLO P/N	Format	No. of Users	No. of Relays	Buttons	Pwr Supply	Illumination	Essex P/N
A	ASCII	Depends on controller type and features	Depends on controller type and features	12	Powered by controller	Illumination can be on all of the time. Must be configured at keypad set-up	K1-26I
CR	For Crestron C2N-IIF	Depends on set-up of Crestron system	Depends on set-up of Crestron system	12	Powered by C2N-IIF	Programmable: ON with button press ON all of the time OFF all of the time	KP-26TI
S12	Stand-alone no controller required	500	1 Plus 2 grounding outputs -external relays required	12	12 VDC 1.25 A supplied	Illumination can be on all of the time. Must be configured at keypad set-up	SKE-26I
W	26 Bit Wiegand	Depends on controller type and features	Depends on controller type and features	12	Powered by controller	Cut jumper wire - turns illumination on all of the time	KTP-102LI